Tag Archives: mold release

Testing DCPD Blend Laminates

By Tom Pawlak

Gougeon Brothers recently did R&D testing for a manufacturer who wanted to know if WEST SYSTEMĀ® epoxy could effectively repair injection-molded parts made with fiberglass and dicyclopentadiene (DCPD) blended polyester resin that included an internal mold release. The hoods and decks for many jet skis and snowmobiles are made with this material.

DCPD blends in polyester cause it to cure rapidly and cross-link thoroughly. This feature helps to reduce emissions from the resin but makes it difficult to repair Continue reading

Mold Release, PVA and Hairspray

By Tom Pawlak

PVA (polyvinyl alcohol) is a water-based liquid plastic that can be applied to waxed molds to prevent molded parts from sticking. PVA is not always required. Often laminators rely solely on mold release wax to create a surface contaminant on the mold that allows parts to be removed. However, on complicated molds and on new molds, when the risk of sticking a part in a mold is greatest, PVA can be applied over a waxed mold to minimize the chance of sticking a part.

PVA can be applied by brush, paint roller or with spray equipment. PVA often leaves a texture on the surface of the mold after it dries. This texture is duplicated or molded into the Continue reading