Fairing Basics

By Jeff Wright

The goal of fairing is to create a surface without bumps or hollows.

Fairing Compound should be of a consistency that can be troweled onto a surface without sagging. Add 407 Low Density or 410 Microlight filler to mixed epoxy, checking the consistency as you stir in the filler to determine if the mixture has the correct viscosity for your application.

 


 

selecting epoxy hardener

Consider ambient temperature when selecting hardener

 

When selecting your hardener, consider the required working time, the ambient temperature, amount of epoxy that will be mixed, and desired cure speed.

 

 


Picture7

Highly thickened fairing compound mixtures will have very little epoxy available to wet the surface of the hull and may be an issue on porous surfaces such as wood. To ensure good adhesion with highly thickened mixtures, apply a thin coat of unthickened epoxy to the surface before troweling on the fairing compound. The fairing compound can be applied right after you apply the unthickened coat, but you may want to wait until the unthickened coat becomes tacky so a thick application of fairing compound does not slide on the surface.


 

Use a chalk and a batten (a long, flat, strip of metal, plastic or knot-free wood) to find the low and high spots on the surface, then decide whether to proceed by filling in low spots or removing high spots.


 

Picture12

After marking the low spots, use a spreader with a notch to create a “guide.”  After a strip of fairing compound is applied, the batten can be wrapped in release fabric and placed into the fairing compound. After these strips cure, fairing compound can be applied between them to fair in the entire surface.


 

Reduce sanding by applying the first layer of fairing compound with a notched trowel. Only the top of the ridges formed by the trowel will be cut by the sand paper. A second application will fill in the valleys.


 

 

Templates are very useful when fairing foils and can be created from a drawing or a surface. Tracing the shape onto a board gives you a rough shape and then a batten can be used to make it a fair curve. The template can be used to form guides to assist in the application of fairing compound on the rest of the foil’s surface.


 

When removing material it is very important to use a “long board” which you may have to make yourself. The sanding board must be flexible enough to bend, but stiff enough that it will maintain a fair curved when it does flex. In many cases automotive type body work tools will be too short and dual action rotary sanders should be used only for creating a profile on the surface.


 

Custom scrapers

Cutaway: Hacksaw blade glued in place with G/5 Adhesiive. Right: 1/4″ wood strips. Thickness may very to adjust flexibility. Vary teeth-per-inch of hacksaw blade for more or less abrasion.

Scrapers are a great tool for removing drips, runs and ridges because they will cut away only the protruding surface defect. They can be purchased, or made from hacksaw blades.

 


Sandwich foam between heavy-duty cloth-backed vinyl. Saw cut through bottom vinyl and foam core only.

Sandwich foam between heavy-duty cloth-backed vinyl. Saw cut through bottom vinyl and foam core only.

Custom sanding tools may be required for gunwales, toe rails and style lines. This example shows a tool that flexes only in one direction and could be used on the chine of a round bilge hull.

 

 

 


Tipping off epoxy

A coat of thickened epoxy creates a uniform and stable surface ahead of final finish

When all the fairing is completed the surface often consists of a combination of fiberglass laminate, fairing compound and old paint or gelcoat. By applying a coat of thickened epoxy to the entire surface, a more uniform and stable surface will be created ensuring an excellent surface for the final finish.